AS7225 datasheet(18/76 Pages) OSRAM

18 / 76 page

Document Feedback

AS7225

Functional Description

Datasheet

• PUBLIC

DS000496

• v2-00 • 2019-Jun-28

│ 17

programming is finished and the programming tool is disconnected the indicator LED turns on. In case

of an error while programming the LED starts a blinking operation.

The LED_IND pin is set for 1 mA LED operation by the AS7225 factory firmware, and is not under

user control. The indicator LED can be enabled or disabled by using the ATLED0 command or the

LED_CONFIG register (0x07). Consideration should be taken with respect to any final product design

to avoid light intrusion from the indicator LED into the direct or reflected field of view of the sensor.

Refer to the separate ams document for a complete description of AS7225 Firmware Update

Methodology.

7.3.2

Interrupt Operation

The INT-pin informs the external MCU that the calculation of new PWM values is finished and the data

are ready to read. To activate the INT-pin, bit1 of the DIR_CONF command has to be enabled

(INT=1). By using UART the ATINTRP command has to be enabled. When the DATA_RDY register bit

finished the integration and the new PWM value calculation is finished the INT-pin of the DIR_CONF

reset to 1 automatically.

AS7225 Scheda tecnica(PDF) 18 Page - OSRAM GmbH