| Motore di ricerca datesheet componenti elettronici |
|
DSP56303 Scheda tecnica(PDF) 204 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
DSP56303 Scheda tecnica(HTML) 204 Page - Freescale Semiconductor, Inc |
|
204 / 292 page ![]() DSP56303 User’s Manual, Rev. 2 9-12 Freescale Semiconductor Triple Timer Module 9.3.2.1 Measurement Input Width (Mode 4) In Mode 4, the timer counts the number of clocks that occur between opposite edges of an input signal. After the first appropriate transition (as determined by the TCSR[INV] bit) occurs on the TIO input signal, the counter is loaded with the TLR value. If TCSR[INV] is set, the timer starts on the first high-to-low (1 to 0) signal transition on the TIO signal. If the INV bit is cleared, the timer starts on the first low-to-high (that is, 0 to 1) transition on the TIO signal. When the first transition opposite in polarity to the INV bit setting occurs on the TIO signal, the counter stops. TCSR[TCF] is set and a compare interrupt is generated if the TCSR[TCIE] bit is set. The value of the counter (which measures the width of the TIO pulse) is loaded into the TCR, which can be read to determine the external signal pulse width. If the TCSR[TRM] bit is set, the counter is loaded with the TLR value on the first timer clock received following the next valid transition on the TIO input signal, and the count resumes. If TCSR[TRM] is cleared, the counter continues to increment on each timer clock. This process repeats until the timer is disabled. Bit Settings Mode Characteristics TC3 TC2 TC1 TC0 Mode Name Function TIO Clock 0 1 0 0 4 Input width Measurement Input Internal Figure 9-11. Pulse Width Measurement Mode, TRM = 1 Mode 4 (internal clock): TRM = 1 N = write preload M = write compare TE Clock (CLK/2 or prescale CLK) TLR TCR Counter first event M 0N N + 1 M N + 1 N Interrupt Service reads TCR; width NOTE: If INV = 1, a 1-to-0 edge on TIO loads the counter, and a 0-to-1 edge on TIO TCF (Compare Interrupt if TCIE = 1) TIO pin width being measured stops the counter and loads TCR with the count. = M - N clock periods Next 0-to-1 edge on TIO loads counter and process repeats |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |