| Motore di ricerca datesheet componenti elettronici |
|
AS3701 Scheda tecnica(PDF) 42 Page - ams-OSRAM AG |
|
|
|||||||||||||||||||||||||||||
AS3701 Scheda tecnica(HTML) 42 Page - ams-OSRAM AG |
|
42 / 110 page ![]() ams Datasheet Page 41 [v1-11] 2016-Dec-14 Document Feedback AS3701 − Detailed Description – System Functions Figure 50: Reset Levels Note(s): 1. The selection of the range and level is done via OTP. It´s recommended to set the ResVoltRise level 200mV above the ResVoltFall level to have a hysteresis 2. 2.7V is the default value, other levels can be set via SW 3. XRES signal is debounced with the specific mask time for rising- and falling slope of VBAT Stand-By Stand-by allows shutting down all rails or just a selected number and can be achieved by one of the following cases: Enter Via GPIO To enter the Stand-by mode via GPIO command, the following settings have to be done: • Enable just these interrupt sources which should lead to leave the stand-by mode • Make sure that the specified interrupt is inactive (clear the Register [InterruptStatus] by register reading) • Set the gpioX_mode [GPIOxcontrol] to input and the gpioX_iosf [GPIOxcontrol] should be set to Stand-by + vselect input (gpioX_iosf = 6) • Set RegX_select [Reg_Control] and RegX_voltage [RegX_ Voltage] if another voltage is needed during stand-by for up to 2 regulators • Define which regulators should be kept powered during Stand-by mode (sdX_stby_on and ldoX_stby_on [Reg_ standby_mod1]) • Set the off_delay [Startup_Control] for going into stand-by after the GPIO command • Activate the selected GPIO Symbol Parameter Note Min Typ Max Unit VPOR Overall power on reset Monitor on VSUPpower ON reset for all internal functions 1.5 2.0 2.3 V VXRES_rise RESET level for VSUP rising Monitor voltage on VSUP rising level ResVolt Rise(1) V VXRES_fall RESET Level for VSUP falling Monitor voltage on VSUP falling level 2.7 V if SupResEn = 1 only ResVolt Fall(2) V VXRES_mask Mask time for VXRES_fall Duration for VBAT < ResVoltFall until a reset cycle is started (3) FastResEn = 0 3 ms FastResEn = 1 64 μs |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |