AS5130 datasheet(26/41 Pages) AMSCO

Il numero della parte	AS5130

Spiegazioni elettronici	8 Bit Programmable Magnetic Rotary Encoder with Motion Detection & Multiturn

PDF	41 Pages

Scroll/Zoom	100%

Produttore elettronici	AMSCO [ams AG]

Homepage	http://www.ams.com

Logo

26 / 41 page

www.austriamicrosystems.com

Revision 1.00

26 - 41

AS5130

Data Sheet - D e ta i l e d D e s c r i p t i o n

Figure 19.

Figure 21 shows the behavior of the wake up signal. The wake up signal will be low for twakeup = 10us. After that, the

wake up signal will go to tri-state condition. In case of an angle comparison with a result below the threshold, the signal

will remain in tri-state condition. After switching on AVDD, the system needs max. 250us to generate an angle with

maximum accuracy. A WAKE signal cannot be expected until the end of this period.

WAKE Interface

An open drain NMOS structure is used in the WAKE pad. In order to generate a clear output signal level, a pull up

resistor is required. The pad can drive 4mA.

VDD on (fast)

store_ok

POR (40us... 150us)

reset & reset_storage

reset digital core only

Retrieve values from storage registers

WAKE (26 clk periods)

Wait (162 clks - 86us ... 95us)

Compare mode

WAKE_ON

Normal mode

store_ok ?

Copy to Storage

Normal mode

OTP readout (46bit - 140us ... 400us)

true

false

WAKE (20 clk periods)

command rst_otp

OTP readout (OTP <8> = HI

measured –

stored| >

threshold

αα

AS5130 Scheda tecnica(PDF) 26 Page - ams AG