M32CSLASH8A datasheet(37/372 Pages) RENESAS

37 / 372 page

M32C/8A Group

2. Central Processing Unit (CPU)

Rev.1.00

Jul 15, 2007

Page 20 of 352

REJ09B0385-0100

2.1.8.7

Interrupt Enable Flag (I)

The I flag enables maskable interrupts.

Interrupts are disabled when the I flag is set to 0 and enabled when it is set to 1. The I flag becomes 0 when

an interrupt request is acknowledged.

2.1.8.8

Stack Pointer Select Flag (U)

ISP is selected when the U flag is set to 0. USP is selected when the U flag is set to 1.

The U flag becomes 0 when a hardware interrupt request is acknowledged or the INT instruction specifying

software interrupt numbers 0 to 31 is executed.

2.1.8.9

Processor Interrupt Priority Level (IPL)

IPL is 3 bits wide and assigns processor interrupt priority levels from level 0 to level 7.

If a requested interrupt has higher priority than IPL, the interrupt is enabled.

2.1.8.10 Reserved Space

Only write 0 to bits assigned to the reserved space. When read, the bits return undefined values.

2.2

High-Speed Interrupt Registers

Registers associated with the high-speed interrupt are follows:

• Save flag register (SVF)

• Save PC register (SVP)

• Vector register (VCT)

Refer to 11.4 High-Speed Interrupt for details.

2.3

DMAC-Associated Registers

Registers associated with the DMAC are as follows:

• DMA mode register (DMD0, DMD1)

• DMA transfer count register (DCT0, DCT1)

• DMA transfer count reload register (DRC0, DRC1)

• DMA memory address register (DMA0, DMA1)

• DMA memory address reload register (DRA0, DRA1)

• DMA SFR address register (DSA0, DSA1)

Refer to 13. DMAC for details.

M32C/8A Scheda tecnica(PDF) 37 Page - Renesas Technology Corp