UPD1002 datasheet(32/46 Pages) MICROCHIP

32 / 46 page

UPD1002

DS00001760B-page 32

 2014 Microchip Technology Inc.

3.5.2

OPERATION OF THE DUAL HI-SPEED READ SEQUENCE

The SPI controller also supports dual data mode (at 30 MHz SPI speed only). When configured in dual mode, the SPI

controller will automatically handle reads going out to the SPI ROM. When the controller detects a read, the controller

drops the SPI_ROM_CE_N, and puts out a 0x3B, followed by the 24-bit address. The SPI controller then puts out a

DUMMY byte. The next four clocks clock in the first byte. The data appears two bits at a time on data out and data in.

When the first byte is clocked in a ready signal is sent back to the processor, and the processor gets one byte.

After the processor gets the first byte, the address will change. If the address is one more than the last address, the SPI

controller will clock out one more byte. If the address in anything other than one more than the last address, the SPI

controller will terminate the transaction by taking SPI_ROM_CE_N high. As long as the addresses are sequential, the

SPI Controller will keep clocking in data.

FIGURE 3-3:

SPI ROM HI-SPEED READ SEQUENCE

FIGURE 3-4:

SPI ROM DUAL HI-SPEED READ OPERATION

SPI_ROM_CE_N

SPI_ROM_CLK

SPI_ROM_DO

SPI_ROM_DI

MSB

HIGH IMPEDANCE

15 16

12 3 4

DOUT

ADD.

23 24

ADD.

39 40

31 32

47 48

55 56

63 64

71 72

DOUT

N+1

DOUT

N+2

DOUT

N+3

DOUT

N+4

MSB

SPI

CONTROLLER

SPI

ROM

2-Serial to

8-Parallel

CE#

CLK

ADDRESS

CONTROL

CACHE

SPI_ROM_DI

UPD1002

UPD1002 Scheda tecnica(PDF) 32 Page - Microchip Technology

UPD1002 Scheda tecnica(HTML) 32 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Scheda tecnica Scarica

Link URL