| Motore di ricerca datesheet componenti elettronici |
|
UPD1002 Scheda tecnica(PDF) 17 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
UPD1002 Scheda tecnica(HTML) 17 Page - Microchip Technology |
|
17 / 46 page ![]() 2014 Microchip Technology Inc. DS00001760B-page 17 UPD1002 VBUS Discharge VBUS_DISCHARGE O8 This active high output is used to drive a power NFET to discharge VBUS during high-to-low voltage transitions in order to achieve vSafe0V. When asserted, the external MOSFET should conduct to GND through a current limit- ing resistor. This signal de-asserts when the VMON sig- nal voltage reaches a preset value (a percentage of the destination voltage). VBUS Out VBUS_OUT O8 This active high output is used on an Upstream Facing Port (UFP) to tell the hub to stay connected. This signal will remain asserted at all times that a valid VBUS level is present (VBUS minimum of 4.5 V to PD VBUS maximum 20 V+10%) on the UFP, as well as during any voltage transitions or role swaps where the voltage may drop below 4.5V. Note: Per the OTG specification, data connectivity roles can be swapped and a micro-AB con- nector with a micro-A plug inserted can oper- ate as an “upstream” port (as a device). Therefore, VBUS_OUT assertion behavior as per above is not only valid with a micro-B cable, but also a micro-A cable so that the USB data link is not lost during PD swaps. Note: This function is only available in specific device configurations. USB ID Indicator USB_ID_IND O8 This signal is used in micro-AB pinouts to indicate to the OTG host whether a micro-A plug (Legacy, Low Power or PD) is present. If a micro-A plug is present, this pin is low. Otherwise it is high. Emulation Enable CHG_EMU_EN O8 This active high output signal can be used to drive the Emulation Enable pin of a Microchip UCS1001 or similar device that supports BC 1.2. The device will assert this signal whenever operating at VSafe5V without a PD con- tract. Whenever a PD contract is established (even at 5 V), this signal is de-asserted. Note: This function is only available in specific device configurations. TABLE 2-2: PIN DESCRIPTIONS (CONTINUED) Name Symbol Buffer Type Description |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |