ST16C552AIJ68 datasheet(20/39 Pages) EXAR

20 / 39 page

ST16C552/552A

Rev. 3.40

FCR BIT 4-5:

Not Used - initialized to a logic 0.

FCR BIT 6-7: (logic 0 or cleared is the default condi-

tion, RX trigger level = 1)

These bits are used to set the trigger level for the

receive FIFO interrupt.

An interrupt is generated when the number of charac-

ters in the FIFO equals the programmed trigger level.

However the FIFO will continue to be loaded until it is

full.

BIT-7

BIT-6

RX FIFO trigger level

Interrupt Status Register (ISR)

The 552/552A provides four levels of prioritized inter-

rupts to minimize external software interaction. The

Interrupt Status Register (ISR) provides the user with

four interrupt status bits. Performing a read cycle on

the ISR will provide the user with the highest pending

interrupt level to be serviced. No other interrupts are

acknowledged until the pending interrupt is serviced.

Whenever the interrupt status register is read, the

interrupt status is cleared. However it should be noted

that only the current pending interrupt is cleared by the

read. A lower level interrupt may be seen after reread-

ing the interrupt status bits. The Interrupt Source

Table 8 (below) shows the data values (bits 0-3) for the

four prioritized interrupt levels and the interrupt

sources associated with each of these interrupt levels:

Table 8, INTERRUPT SOURCE TABLE

Priority

[ISR BITS]

Level

Bit-3 Bit-2 Bit-1 Bit-0

Source of the interrupt

LSR (Receiver Line Status Register)

RXRDY (Received Data Ready)

RXRDY (Receive Data time out)

TXRDY (Transmitter Holding Register Empty)

MSR (Modem Status Register)

ST16C552AIJ68 Scheda tecnica(PDF) 20 Page - Exar Corporation

ST16C552AIJ68 Scheda tecnica(HTML) 20 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

Scheda tecnica Scarica

Link URL