VNHD7012AYTR datasheet(23/43 Pages) STMICROELECTRONICS

23 / 43 page

DS11484 Rev 5

23/43

VNHD7012AY

Electrical specifications

Note:

To power on the device from standby, it is recommended to: toggle INA or INB or SEL0 or

SEL1 from 0 to 1 first to come out from STBY mode; toggle PWM from 0 to 1 with a delay of

20 microsecond this avoids any overstress on the device in case of existing short-to-battery.

Table 14. Off-state — truth table

Description

Off-state diagnostic

VSENSEH

Case 1: OUTA shorted to VCC if no pull-up is applied.

Case 2: NO open-load in full bridge configuration with

an external pull-up on OUTB

Case 3: open-load in half bridge configuration with an

external pull-up on OUTA (motor connected between

Out and Ground)

Hi-Z

Case 1: open-load in full Bridge configuration with an

external pull-up on OUTB

Case 2: NO open-load in half Bridge configuration

with external pull-up on OUTA (motor connected

between Out and Ground)

1VSENSEH

Case 1: OUTB shorted to VCC if no pull-up is applied

Case 2: NO open-load in full bridge configuration with

external pull-up on OUTA

Case 3: open-load in half bridge configuration with

external pull-up on OUTB (motor connected between

Out and Ground)

1Hi-Z

Case1: open-load in full Bridge configuration with an

external pull-up on OUTA

Case 2. NO open-load in half Bridge configuration

with external pull-up on OUTB (motor connected

between Out and Ground)

VNHD7012AYTR Scheda tecnica(PDF) 23 Page - STMicroelectronics