18

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SECTION 5-CARE & MAINTENANCE

HELMET CARE & MAINTENANCE

Damaged components must be replaced immediately to avoid risk of eye

and face injuries. Periodically inspect the filter cartridge and lenses. Cracked,

pitted or scratched lenses reduce vision and seriously reduce the level of

protection and should be replaced with genuine, certified spare parts.

The cartridge can be wiped with a household glass cleaner when dirty. Apply

the cleaner with a clean cloth or paper towel. DO NOT USE ALCOHOL TO

CLEAN. DO NOT APPLY CLEANER DIRECTLY TO THE CARTRIDGE.

Clean all lenses with a soft tissue and suitable lens cleaning fluid. Do not use

solvents. NEVER use tools or other sharp objects to remove material from the

lens or screen. This may cause damage which may cause incorrect function

and invalidate the warranty. Store the unit in it’s box or similar safe place.

FRONT COVER LENS REPLACEMENT

Replace the front cover lens if it is damaged (cracked, scratched, pitted or

dirty). Remove the old front cover lens by pressing two lock switches at the

bottom of the retaining frame and pull the frame and ADF out. Take the old

front cover lens out, and remove any protective film before installing the new

one.

INSIDE COVER LENS REPLACEMENT

Replace the inside cover lens if it is damaged (cracked, scratched, pitted or

dirty). Place your finger or thumb into the recess and flex the inside cover lens

upwards until it releases from one edge.

Remove any protective film before installing the new one.

BATTERY REPLACEMENT

When the low voltage indicator turns red, the batteries need replacing.

Removing the ADF from the retaining frame. Slide the cover plates on the top

left and right and replace the old lithium ion battery. Replace the cover plates

of the battery and install the ADF back to the frame.

CLEANING AND STORING

Keep the sensors, solar cell and filter lens clean. Clean filter cartridge and

helmet shell by using a soapy water solution and soft cloth. DO NOT use

solvents or abrasive cleaning detergent. Switch the product to Grind Mode

and put it in a clean, dry location for storage.