MB90437LPF datasheet(18/61 Pages) CYPRESS

18 / 61 page

MB90435 Series

DS07-13727-2E

(6) Pull-up/down resistors

The MB90435 Series does not support internal pull-up/down resistors (except Port0

− Port3 : pull-up

resistors) . Use external components where needed.

(7) Crystal Oscillator Circuit

Noises around X0 or X1 pins may be possible causes of abnormal operations. Make sure to provide bypass

capacitors via the shortest distances from X0, X1 pins, crystal oscillator (or ceramic resonator) and ground lines,

and make sure, to the utmost effort, that lines of oscillation circuits do not cross the lines of other circuits.

It is highly recommended to provide a printed circuit board artwork surrounding X0 and X1 pins with a ground

area for stabilizing the operation.

(8) Turning-on Sequence of Power Supply to A/D Converter and Analog Inputs

Make sure to turn on the A/D converter power supply (AVCC, AVRH, AVRL) and analog inputs (AN0 to AN7) after

turning-on the digital power supply (VCC) .

Turn-off the digital power after turning off the A/D converter supply and analog inputs. In this case, make sure

that the voltage does not exceed AVRH or AVCC (turning on/off the analog and digital power supplies simulta-

neously is acceptable) .

(9) Connection of Unused Pins of A/D Converter

Connect unused pins of A/D converter to AVCC

= VCC, AVSS = AVRH = VSS.

(10) N.C. Pin

The N.C. (internally connected) pin must be opened for use.

(11) Notes on Energization

To prevent the internal regulator circuit from malfunctioning, set the voltage rise time during energization at

µs or more (0.2 V to 2.7 V) .

(12) Initialization

In the device, there are internal registers which are initialized only by a power-on reset. To initialize these registers,

please turn on the power again.

(13) Directions of “DIV A, Ri” and “DIVW A, RWi” instructions

In the Signed multiplication and division instructions (“DIV A, Ri” and “DIVW A, RWi”) , the value of the

corresponding bank register (DTB, ADB, USB, SSB) is set in “00H”.

If the values of the corresponding bank registers (DTB, ADB, USB, SSB) are set to other than “00H”, the remainder

by the execution result of the instruction is not stored in the register of the instruction operand.

(14) Using REALOS

The use of EI2OS is not possible with the REALOS real time operating system.

(15) Caution on Operations during PLL Clock Mode

If the PLL clock mode is selected, the microcontroller attempt to be working with the self-oscillating circuit even

when there is no external oscillator or external clock input is stopped. Performance of this operation, however,

cannot be guaranteed.

MB90437LPF Scheda tecnica(PDF) 18 Page - Cypress Semiconductor