WM8912 datasheet(78/129 Pages) CIRRUS

78 / 129 page

WM8912

Production Data

PD, Rev 4.1, February 2013

INTERRUPTS

The Interrupt Controller has multiple inputs; these include the GPIO input pins and other internal

signals. Any combination of these inputs can be used to trigger an Interrupt Output (IRQ) event.

WM8912 interrupt events may be triggered in response to external GPIO inputs, FLL Lock status or

Write Sequencer status. Note that the GPIO inputs are only supported as interrupt events when the

respective pin is configured as a GPIO input.

There is an Interrupt Status field associated with each of the IRQ inputs. These are contained in the

Interrupt Status Register (R127), as described in Table 54. The status of the IRQ inputs can be read

from this register at any time, or in response to the Interrupt Output being signalled via a GPIO pin.

Individual mask bits can select or deselect different functions from the Interrupt controller. These are

listed within the Interrupt Status Mask register (R128), as described in Table 54. Note that the

Interrupt Status fields remain valid, even when masked, but the masked bits will not cause the

Interrupt (IRQ) output to be asserted.

The Interrupt (IRQ) output represents the logical ‘OR’ of all unmasked IRQ inputs. The bits within the

Interrupt Status register (R127) are latching fields and, once set, are not reset until a ‘1’ is written to

the respective register bit in the Interrupt Status Register. The Interrupt (IRQ) output is not reset until

each of the unmasked IRQ inputs has been reset.

Each of the IRQ inputs can be individually inverted in the Interrupt function, enabling either active

high or active low behaviour on each IRQ input. The polarity inversion is controlled using the bits

contained in the Interrupt Polarity register (R129).

Each of the IRQ inputs can be debounced to ensure that spikes and transient glitches do not assert

the Interrupt Output. This is selected using the bits contained in the Interrupt Debounce Register

(R130).

The WM8912 Interrupt Controller circuit is illustrated in Figure 45. The associated control fields are

described in Table 54.

Figure 45 Interrupt Controller

WM8912 Scheda tecnica(PDF) 78 Page - Cirrus Logic