AC08FSM datasheet(154/223 Pages) TECCOR

154 / 223 page

AN1006

Application Notes

http://www.teccor.com

AN1006 - 2

+1 972-580-7777

Thyristor Product Catalog

Safety (Cautions and Warnings)

Adhere rigidly to Tektronix safety rules supplied with each

curve tracer. No attempt should be made to defeat any of the

safety interlocks on the device as the curve tracer can produce a

lethal shock. Also, older 575 models do not have the safety inter-

locks as do the new models. Take care never to touch any device

or open the terminal while energized.

WARNING: Devices on the curve tracer may be easily dam-

aged from electrical overstress.

Follow these rules to avoid destroying devices:

•

Familiarize yourself with the expected maximum limits of the

device.

•

Limit the current with the variable resistor to the minimum nec-

essary to conduct the test.

•

Increase power slowly to the specified limit.

•

Watch for device “runaway” due to heating.

•

Apply and increase gate or base drive slowly and in small

steps.

•

Conduct tests in the minimum time required.

General Test Procedures

Read all manuals before operating a curve tracer.

Perform the following manufacturer’s equipment check:

1. Turn on and warm up curve tracer, but turn off, or down, all

power supplies.

2. Correctly identify terminals of the device to be tested. Refer

to the manufacturer’s guide if necessary.

3. Insert the device into the test fixture, matching the device

and test terminals.

4. Remove hands from the device and/or close interlock cover.

5. Apply required bias and/or drive.

6. Record results as required.

7. Disconnect all power to the device before removing.

Model 576 Curve Tracer Procedures

The following test procedures are written for use with the model

576 curve tracer. (Figure AN1006.1)

See “Model 370 Curve Tracer Procedure Notes” on page

AN1006-16 and “Model 577 Curve Tracer Procedure Notes” on

page AN1006-18 for setting adjustments required when using

model 370 and 577 curve tracers.

The standard 575 model lacks AC mode, voltage greater than

200 V, pulse operations, DC mode, and step offset controls. The

575 MOD122C does allow voltage up to 400 V, including 1500 V

in an AC mode. Remember that at the time of design, the 575

was built to test only transistors and diodes. Some ingenuity,

experience, and external hardware may be required to test other

types of devices.

For further information or assistance in device testing on Tek-

tronix curve tracers, contact the Teccor Applications Engineering

group.

AC08FSM Scheda tecnica(PDF) 154 Page - Teccor Electronics

AC08FSM Scheda tecnica(HTML) 154 Page - Teccor Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL