AD9957SLASHPCBZ datasheet(30/61 Pages) AD

30 / 61 page

AD9957

Data Sheet

Rev. F | Page 30 of 61

RAM Bidirectional Ramp Mode

This mode is unique in that the RAM segment playback mode

word of both RAM segment registers must be programmed for

RAM bidirectional ramp mode.

In bidirectional ramp mode, upon assertion of an I/O update,

the RAM readies for playback operation using the parameters

programmed into RAM Segment Register 0. The data is deliv-

ered at the appropriate rate and to the destination as specified

by the RAM playback destination bit.

The playback rate is governed by the timer that is internal to the

RAM state machine, and its period (Δt) is determined by the

state of the RAM playback destination bit as detailed in the

RAM Playback Operation section.

Playback begins upon a 0 to 1 logic transition on the RT pin.

This instructs the state machine to increment through the

address range specified in RAM Segment Register 0 starting

with the start address. As long as the RT pin remains Logic 1,

the state machine continues to play back the RAM data until it

reaches the end address, at which point the state machine halts.

A Logic 1 to Logic 0 transition on the RT pin instructs the state

machine to switch to RAM Segment Register 1 and to decrement

through the address range starting with the end address. As

long as the RT pin remains Logic 0, the state machine continues

to play back the RAM data until it reaches the start address, at

which point the state machine halts.

It is important to note that RAM Segment Register 1 is played

back in reverse order for bidirectional ramp mode. Keep this in

mind when the RAM contents are loaded via the serial I/O port

when bidirectional ramp mode is the intended playback mode.

A graphic representation of the bidirectional ramp mode

appears in Figure 44. It demonstrates the action of the state

machine in response to the RT pin. If the RT pin changes states

before the state machine reaches the programmed start or end

address, the internal timer is restarted and the direction of the

address counter reversed.

RAM SEGMENT

∆t

START ADDRESS NUMBER 1

START ADDRESS NUMBER 0

END ADDRESS NUMBER 1

END ADDRESS

NUMBER 0

RAM

ADDRESS

RAM

ADDRESS

1 PDCLK CYCLE

M DDS CLOCK CYCLES

I/O_UPDATE

Figure 44. Bidirectional Ramp Timing Diagram

AD9957/PCBZ Scheda tecnica(PDF) 30 Page - Analog Devices

AD9957/PCBZ Scheda tecnica(HTML) 30 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

Scheda tecnica Scarica

Link URL