2. TEACH the Sensing Conditions.

Method

Action

Result

Push Button

Present the Output ON/OFF conditions while

continuing to hold the Dynamic button.

Remote Input

Present the Output ON/OFF conditions while

continuing to hold the remote line low (to ground).

3. Return to RUN Mode.

Method

Action

Result

Push Button

Release the Dynamic button.

TEACH conditions accepted

•

Display flashes “PASS,”

followed by a number (denoting

contrast); see Figure 5 on page

5

•

Sensor returns to RUN mode

with new settings

•

Arrow icon turns green

TEACH conditions not accepted

•

Display flashes “FAIL”

•

Arrow icon remains red

•

Sensor returns to RUN mode

(Arrow icon turns green)

without changing settings

Remote Input

Release the remote line/switch.

Single-Point Window Set

•

Sets a single ON condition that extends 200 counts above and below the taught condition (including ±100 counts

hysteresis)

•

All other conditions (lighter or darker) result in OFF output

•

Sensing window size (sensitivity) is adjustable using “+” and “-” buttons (see Manual Adjust on page 10)

Window Set is most useful when a product may not always appear in

the same place, or when other signals may appear. Window Set

designates a sensing window, with the Output ON condition inside

the window, and the Output OFF conditions outside the window. The

sensor accepts a single sensing condition, and adds switching

thresholds and hysteresis above and below that condition to create a

sensing window. Output ON and OFF conditions can be reversed by

changing Light/Dark Operate status in Setup mode.

Window Set and Manual Adjust

Using Manual Adjust with Window Set expands or contracts the size

of the window.

Sensor positions

window thresholds

± 100 counts from the

presented condition

Darkest

(no signal)

Most Light

(saturated

signal)

Taught

Condition

200 counts

Hysteresis

100 counts

Hysteresis

100 counts

Output OFF

Output OFF

Output ON

Sensing window size adjusted by

Manual Adjust

Figure 6. Single-Point Window SET and Hysteresis (Light

Operate shown)

1. Access the SET Mode.

Method

Action

Result

Push Button

Press and hold the Static (-) button > 2 seconds.

•

Display flashes “1St”

•

Arrow icon turns red

6

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 64154 Rev. G