Self-Diagnostic Error Modes

In the unlikely event that the setup parameters are lost or become corrupt, the display will continuously scroll: “USEr PSF

Error.” Reteach the sensor to recover. If the problem persists, contact your Banner representative for further information.

Gate Input

The pink wire is configured as a gate input. When this wire is pulled low (for example, to the sensor ground; 0–0.5 V dc),

it inhibits the outputs from switching, while all other sensor functions continue to be enabled. This feature is useful for

controlling when the outputs are allowed to change states. Gate input function response time is 1 millisecond.

Specifications

Required Fiber-Optic Cable

Banner P-Series plastic fibers

Sensing Beam

Visible red, 680 nm or Visible green, 525 nm , depending on model

Supply Voltage and Current

12 to 24V dc (10% maximum ripple) at less than 65 mA, exclusive of

load

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Output Configuration

2 NPN or 2 PNP, depending on model

Output Rating

150 mA maximum load

OFF-state leakage current: < 10 μA at 24 V dc

ON-state saturation voltage:

NPN < 1.5 V at 150 mA load

PNP < 2.5 V at 150 mA load

Output Protection Circuitry

Protected against false pulse on power-up and continuous short-circuit

Output Response Time

Programmable, 50 microseconds, 200 microseconds, 1 millisecond, 2.5

milliseconds

NOTE: < 1 second delay on power-up;

outputs do not conduct during this time.

Adjustments

Push-button or remote programming of response time, OFF-delay,

light/dark operate, and display

Indicators

Four-digit digital display plus LED indicators for active channel, push-

button lockout, OFF-delay and light/dark operate selection; 2 yellow

output indicators

Construction

Black ABS/polycarbonate alloy (UL94 V-0 rated) housing, clear

polycarbonate cover

Environmental Rating

NEMA 1, IEC IP50

Connections

PVC-jacketed 2 m or 9 m (6.5' or 30') 6-wire integral cable or integral

6-pin Pico-style quick-disconnect

Operating Conditions

Temperature: −20 °C to +55 °C (−4 °F to +131°F)

Storage Temperature: −20 °C to +80 °C (−4 °F to +176 °F)

90% at +50 °C maximum relative humidity (non-condensing)

Number of Devices,

Stacked

Ambient Temperature

Rating

Load Specification

3

55 °C

150 mA

7

50 °C

50 mA

10

45 °C

50 mA

Required Overcurrent Protection

WARNING: Electrical connections must be

made by qualified personnel in accordance

with local and national electrical codes and

regulations.

Overcurrent protection is required to be provided by end product

application per the supplied table.

Overcurrent protection may be provided with external fusing or via

Current Limiting, Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go to www.bannerengineering.com.

Supply Wiring (AWG)

Required Overcurrent Protection (Amps)

20

5.0

22

3.0

24

2.0

26

1.0

28

0.8

30

0.5

Certifications

14

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 64154 Rev. G