Method

Action

Result

Push Button

a. Click Dynamic (+) to toggle between

selections.

b. Click Static (-) to save selection and return

to RUN mode.

OR

c. Press Static (-) four times to proceed to

Advanced Setup.

Indicator Arrow Icons 1 and 2 ON Red

Super-high-speed (50-μs response)

"SHS" (Complementary outputs; see note

below)

High-speed (200-μs response)

"HS"

High-power (1-ms response)

"HP"

Super-high-power (2.5-ms response)

"SHP"

OR

See Advanced Setup on page 12.

Remote Input

a. Double pulse the remote line to toggle

between selections.

b. Single-pulse the remote line to save

selection and return to RUN mode.

OR

c. Four-pulse the remote line to proceed to

Advanced Setup.

T

T

T

T

T

T

T

T

T

T

T

Super-High-Speed Operation Note: Under most conditions, the sensor’s two discrete outputs

operate independently. However, the outputs become complementary when operating at Super-High-

Speed, due to its extremely fast response time. Only channel 1 is taught/adjusted; channel 2 is

complementary to it (output 1 conducts for the taught ON condition, and output 2 conducts for the OFF

state). To invert these conditions (output 1 – OFF condition, output 2 – ON), change light/dark operate

setting.

Advanced Setup

•

Advanced adjustments to previously configured sensor display and operating parameters

•

Quad-click Static (-) or quad-pulse remote line before exiting “Power and Speed” settings to enter this mode

•

Click Dynamic (+) or double-pulse remote line to select an option

•

Click Static or single-pulse remote line to advance

•

Changes are updated instantly

1. Enter SETUP Mode.

Method

Action

Result

Push Button20

From the Power and Speed mode, quad-click

the Static (-) button.

•

Indicator Arrow Icons 1 and 2

remain red

•

Display shows "Tracking

Enabled" option

Remote Input21

From the Power and Speed mode, quad-pulse

the remote line.

T

T

T

T

T

T

T

2. Set tracking, if desired.

Method

Action

Result

Push Button

a. Click Dynamic (+) to toggle between selections.

b. Click Static (-) to save selection and advance to

"Factory Default."

Sets output 2 identical to output 1

Tracking Disabled: Display shows "tr n"

Tracking Enabled: Display shows "tr Y"

20 0.04 seconds ≤ "Click" ≤ 0.8 seconds

21 0.04 seconds ≤ T ≤ 0.8 seconds

12

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 64154 Rev. G