LAN9312 datasheet(18/458 Pages) SMSC

18 / 458 page

High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface

Datasheet

Revision 1.2 (04-08-08)

SMSC LAN9312

DATASHEET

1.2

Buffer Types

Table 1.1 describes the pin buffer type notation used in Chapter 3, "Pin Description and Configuration,"

on page 26 and throughout this document.

Table 1.1 Buffer Types

BUFFER TYPE

DESCRIPTION

Schmitt-triggered Input

Output with 8mA sink and 8mA source

OD8

Open-drain output with 8mA sink

O12

Output with 12mA sink and 12mA source

OD12

Open-drain output with 12mA sink

50uA (typical) internal pull-up. Unless otherwise noted in the pin description, internal pull-

ups are always enabled.

Note:

Internal pull-up resistors prevent unconnected inputs from floating. Do not rely on

internal resistors to drive signals external to the LAN9312. When connected to a

load that must be pulled high, an external resistor must be added.

50uA (typical) internal pull-down. Unless otherwise noted in the pin description, internal

pull-downs are always enabled.

Note:

Internal pull-down resistors prevent unconnected inputs from floating. Do not rely

on internal resistors to drive signals external to the LAN9312. When connected to

a load that must be pulled low, an external resistor must be added.

Analog input

Analog output

AIO

Analog bi-directional

ICLK

Crystal oscillator input pin

OCLK

Crystal oscillator output pin

Power pin

LAN9312 Scheda tecnica(PDF) 18 Page - SMSC Corporation