DIO7S104

Version 1.5, Dec 2025

www.dioo.com

© 2025 Dioo Microcircuits Co., Ltd. Jiangsu

18

10.3. Enable and disable

The DIO7S104 device has an OE input that disables the device by setting OE low, which places all I/Os in the

high-impedance (Hi-Z) state. The disable time (tdis) represents the delay between OE going low and the outputs

getting disabled (Hi-Z). The enable time (ten) represents the amount of time that the user must allow a one-shot

circuit to operate after EN is high.

10.4. Pullup or pulldown resistors on I/O lines

Every I/O on the A-port features an integrated 10 kΩ pull-up resistor connected to VCCA, while every I/O on the

B-port features an integrated 10 kΩ pull-up resistor connected to VCCB. When a lower resistance pull-up

resistor is necessary, add an external resistor from the I/O to either VCCA or VCCB, in parallel with the existing

internal 10 kΩ resistors.

10.5. Device functional modes

There are two functional modes for the device: enabled and disabled. The device can be enabled by setting the

OE input high. To disable the device, set the OE input low, which places all I/Os in a high impedance state.