ATmega162 datasheet(79/324 Pages) ATMEL

79 / 324 page

2513K–AVR–07/09

ATmega162/V

• TOSC1/XCK0/OC3A – Port D, Bit 4

TOSC1, Timer Oscillator pin 1: When the AS2 bit in ASSR is set (one) to enable asynchronous

clocking of Timer/Counter2, pin PD4 is disconnected from the port, and becomes the input of the

inverting Oscillator Amplifier. In this mode, a crystal Oscillator is connected to this pin, and the

pin can not be used as an I/O pin.

XCK0, USART0 External Clock: The Data Direction Register (DDD4) controls whether the clock

is output (DDD4 set (one)) or input (DDD4 cleared (zero)). The XCK0 pin is active only when

USART0 operates in Synchronous mode.

OC3A, Output Compare Match A output: The PD4 pin can serve as an external output for the

Timer/Counter1 Output Compare A. The pin has to be configured as an output (DDD4 set (one))

to serve this function. The OC4A pin is also the output pin for the PWM mode timer function.

• INT1/ICP3 – Port D, Bit 3

INT1, External Interrupt Source 1: The PD3 pin can serve as an external interrupt source.

ICP3, Input Capture Pin: The PD3 pin can act as an Input Capture pin for Timer/Counter3.

• INT0/XCK1 – Port D, Bit 2

INT0, External Interrupt Source 0: The PD2 pin can serve as an external interrupt source.

XCK1, USART1 External Clock: The Data Direction Register (DDD2) controls whether the clock

is output (DDD2 set (one)) or input (DDD2 cleared (zero)). The XCK1 pin is active only when

USART1 operates in Synchronous mode.

• TXD0 – Port D, Bit 1

TXD0, Transmit Data (Data output pin for USART0). When the USART0 Transmitter is enabled,

this pin is configured as an output regardless of the value of DDD1.

ATmega162 Scheda tecnica(PDF) 79 Page - ATMEL Corporation