| Motore di ricerca datesheet componenti elettronici |
|
WM9093ECS/R Scheda tecnica(PDF) 10 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM9093ECS/R Scheda tecnica(HTML) 10 Page - Wolfson Microelectronics plc |
|
10 / 84 page ![]() WM9093 Production Data w PD, March 2012, Rev 4.2 10 Test Conditions SVDD = 3.6V, HPVDD=1.8V, GND=0V, TA = +25 oC, 1kHz signal, PGA gain = 0dB unless otherwise stated PARAMETER TEST CONDITIONS MIN TYP MAX UNIT Digital Input / Output Input HIGH Level 0.7 HPVDD V Input LOW Level 0.3 HPVDD V Output HIGH Level IOL=1mA 0.7 HPVDD V Output LOW Level IOH=-1mA 0.3 HPVDD V Maximum Signal Level 2.7 V Input capacitance 10 pF Input leakage -0.9 0.9 uA Start-Up Time Start up time Speaker and Headphone 35 ms Note 1: Total system PSRR with external DC-DC or LDO will be higher. TERMINOLOGY 1. Signal-to-Noise Ratio (dB) – SNR is a measure of the difference in level between the maximum full scale output signal and the output with no input signal applied. 2. Total Harmonic Distortion (dB) – THD is the level of the rms value of the sum of harmonic distortion products relative to the amplitude of the measured output signal. 3. Total Harmonic Distortion plus Noise (dB) – THD+N is the level of the rms value of the sum of harmonic distortion products plus noise in the specified bandwidth relative to the amplitude of the measured output signal. 4. Crosstalk (L/R) (dB) – left-to-right and right-to-left channel crosstalk is the measured signal level in the idle channel at the test signal frequency relative to the signal level at the output of the active channel. The active channel is configured and supplied with an appropriate input signal to drive a full scale output, with signal measured at the output of the associated idle channel. 5. Mute Attenuation – This is a measure of the difference in level between the full scale output signal and the output with mute applied. 6. All performance measurements carried out with 20kHz low pass filter, and where noted an A-weighted filter. Failure to use such a filter will result in higher THD and lower SNR readings than are found in the Electrical Characteristics. The low pass filter removes out of band noise; although it is not audible it may affect dynamic specification values. |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |