CS22210 datasheet(9/31 Pages) CIRRUS

9 / 31 page

CS22210 PCI/USB Wireless Controller

9 of 31

D556PP2

Rev. 3.0

www.cirrus.com

This section provides detailed information on the CS22210 signals. The signal descriptions are

useful for hardware designers who are interfacing the CS22210 with other devices.

System Memory Interface

The system memory interface supports standard SDRAM interface, async SRAM and FLASH.

There are total of 37 signals in this interface.

SMCLK

Output

System mem clock for SDRAM. Currently the interface supports 103 MHz

for a maximum bandwidth of 200Mbytes/sec.

nSMCS0

Output

Chip select bit 0. This signal is used to select or deselect the SDRAM for

command entry.

When SMNCS is low it qualifies the sampling of

nSMRAS, nSMCAS and nSMWE. Also used as testmode(2) when NTEST

pin is '0'.

nSMCS

Output

Chip select bit 1.

nBRCE

Output

Chip select for ROM access. This signal is used to select or deselect the

boot ROM memory.

nSMRAS

Output

Row address select. Used in combination with nSMCAS, nSMWE and

nSMCS to specify which SDRAM page to open for access. Also used

during reset to latch in the strap value for clk_bypass; if set to a '1' implies

bypassing clock module; whatever clk is applied on the input clock is used

for memclk and ctlclk. Also shared as the ROMOE signal.

NSMCAS

Output

Column address select. Used in combination with nSMRAS, nSMWE and

nSMCS to specify which piece of data to access in selected page. Also

used during reset to latch in the strap value for same_freq; if set to a '1'

implies internal mem_clk and arm_clk are running at the same frequency

and 180 degrees out of phase.

CS22210 Scheda tecnica(PDF) 9 Page - Cirrus Logic

CS22210 Scheda tecnica(HTML) 9 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Scheda tecnica Scarica

Link URL