CS22210 datasheet(13/31 Pages) CIRRUS

13 / 31 page

CS22210 PCI/USB Wireless Controller

13 of 31

D556PP2

Rev. 3.0

www.cirrus.com

BBAS

Output

Baseband address strobe is used to envelop the address or the data on

the BBSDX bus. Logic 1 envelops the address and a logic 0 envelops the

data. This signal has to be set up to the rising edge of BBSCLK for the

baseband processor and is driven on the falling edge of BBSCLK.

NBBCS

Output

Baseband chip select is an active low output to activate the serial control

port. When inactive the SD, BBSCLK, BBAS and BBRNW signals are

‘don’t cares’.

TXPAPE

Output

Radio power amplifier power enable is a software-controlled output. This

signal is used to gate power to the power amplifier.

TXPE

Output

Radio transmit power enable indicates if transmit mode is enabled. When

low, this signal indicates receive mode.

RXPEBB

Output

Baseband receive power enable is an output that indicates if the MAC is in

receive mode. This output to the baseband processor enables receive

mode in baseband processor.

BBSCLK

Output

Baseband serial clock is a programmable output generated by dividing

ARM_CLK by 14 (default). This clock is used for the serial control port to

sample the control and data signals.

BBSDX

Bi-directional

Baseband serial data is a bi-directional serial data bus, which is used to

transfer address and data to/from the internal registers of the baseband

processor.

SYNTHLE

Output

Synthesizer latch enable is an active high signal used to send data to the

synthesizer.

SYNTH_LE1

Output

Synthesizer latch enable is an active high signal used to send data to the

synthesizer (RF LE).

SYNTH_LE2

Output

Synthesizer latch enable is an active high signal used to send data to the

synthesizer (IF LE).

CS22210 Scheda tecnica(PDF) 13 Page - Cirrus Logic

CS22210 Scheda tecnica(HTML) 13 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Scheda tecnica Scarica

Link URL