| Motore di ricerca datesheet componenti elettronici |
|
C161PI Scheda tecnica(PDF) 17 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
C161PI Scheda tecnica(HTML) 17 Page - Infineon Technologies AG |
|
17 / 82 page ![]() &3, Data Sheet 15 1999-07 External Bus Controller All of the external memory accesses are performed by a particular on-chip External Bus Controller (EBC). It can be programmed either to Single Chip Mode when no external memory is required, or to one of four different external memory access modes, which are as follows: – 16-/18-/20-/23-bit Addresses, 16-bit Data, Demultiplexed – 16-/18-/20-/23-bit Addresses, 16-bit Data, Multiplexed – 16-/18-/20-/23-bit Addresses, 8-bit Data, Multiplexed – 16-/18-/20-/23-bit Addresses, 8-bit Data, Demultiplexed In the demultiplexed bus modes, addresses are output on PORT1 and data is input/ output on PORT0 or P0L, respectively. In the multiplexed bus modes both addresses and data use PORT0 for input/output. Important timing characteristics of the external bus interface (Memory Cycle Time, Memory Tri-State Time, Length of ALE and Read Write Delay) have been made programmable to allow the user the adaption of a wide range of different types of memories and external peripherals. In addition, up to 4 independent address windows may be defined (via register pairs ADDRSELx / BUSCONx) which allow to access different resources with different bus characteristics. These address windows are arranged hierarchically where BUSCON4 overrides BUSCON3 and BUSCON2 overrides BUSCON1. All accesses to locations not covered by these 4 address windows are controlled by BUSCON0. Up to 5 external CS signals (4 windows plus default) can be generated in order to save external glue logic. The C161PI offers the possibility to switch the CS outputs to an unlatched mode. In this mode the internal filter logic is switched off and the CS signals are directly generated from the address. The unlatched CS mode is enabled by setting CSCFG (SYSCON.6). Access to very slow memories is supported via a particular ‘Ready’ function. For applications which require less than 8 MBytes of external memory space, this address space can be restricted to 1 MByte, 256 KByte or to 64 KByte. In this case Port 4 outputs four, two or no address lines at all. It outputs all 7 address lines, if an address space of 8 MBytes is used. |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |