LSM6DSLTR datasheet(30/113 Pages) STMICROELECTRONICS

30 / 113 page

Functionality

LSM6DSL

30/113

DocID028475 Rev 5

Functionality

5.1

Operating modes

In the LSM6DSL, the accelerometer and the gyroscope can be turned on/off independently

of each other and are allowed to have different ODRs and power modes.

The LSM6DSL has three operating modes available:

 only accelerometer active and gyroscope in power-down

 only gyroscope active and accelerometer in power-down

 both accelerometer and gyroscope sensors active with independent ODR

The accelerometer is activated from power-down by writing ODR_XL[3:0] in CTRL1_XL

(10h) while the gyroscope is activated from power-down by writing ODR_G[3:0] in

CTRL2_G (11h). For combo-mode the ODRs are totally independent.

5.2

Gyroscope power modes

In the LSM6DSL, the gyroscope can be configured in four different operating modes: power-

down, low-power, normal mode and high-performance mode. The operating mode selected

depends on the value of the G_HM_MODE bit in CTRL7_G (16h). If G_HM_MODE is set to

'0', high-performance mode is valid for all ODRs (from 12.5 Hz up to 6.66 kHz).

To enable the low-power and normal mode, the G_HM_MODE bit has to be set to '1'. Low-

power mode is available for lower ODRs (12.5, 26, 52 Hz) while normal mode is available

for ODRs equal to 104 and 208 Hz.

5.3

Accelerometer power modes

In the LSM6DSL, the accelerometer can be configured in four different operating modes:

power-down, low-power, normal mode and high-performance mode. The operating mode

selected depends on the value of the XL_HM_MODE bit in CTRL6_C (15h). If

XL_HM_MODE is set to '0', high-performance mode is valid for all ODRs (from 12.5 Hz up

to 6.66 kHz).

To enable the low-power and normal mode, the XL_HM_MODE bit has to be set to '1'. Low-

power mode is available for lower ODRs (1.6, 12.5, 26, 52 Hz) while normal mode is

available for ODRs equal to 104 and 208 Hz.

LSM6DSLTR Scheda tecnica(PDF) 30 Page - STMicroelectronics