WM8952ECSSLASHRV datasheet(41/72 Pages) WOLFSON

Il numero della parte	WM8952ECS/RV

Spiegazioni elettronici	Mono ADC with Microphone Pre-amplifier

PDF	72 Pages

Scroll/Zoom	100%

Produttore elettronici	WOLFSON [Wolfson Microelectronics plc]

Homepage	http://www.wolfsonmicro.com

Logo

41 / 72 page

Pre Production

WM8952

PP, Rev 3.1, June 2011

In I2S mode, the MSB is available on the second rising edge of BCLK following a FRAME transition.

The other bits up to the LSB are then transmitted in order. Depending on word length, BCLK

frequency and sample rate, there may be unused BCLK cycles between the LSB of one sample and

the MSB of the next.

Figure 21 I2S Audio Interface (assuming n-bit word length)

In DSP/PCM mode, the left channel MSB is available on either the 1st (Mode B) the 2nd (Mode A)

rising edge of BCLK (selectable by FRAMEP) following a rising edge of FRAME. Right channel data

immediately follows left channel data. Depending on word length, BCLK frequency and sample rate,

there may be unused BCLK cycles between the LSB of the right channel data and the next sample.

FRAMEP should be set to 0 in this mode.

Figure 22 DSP/PCM Mode Audio Interface (Mode A, FRAMEP=0)

Figure 23 DSP/PCM Mode Audio Interface (Mode B, FRAMEP=1)

WM8952ECS/RV Scheda tecnica(PDF) 41 Page - Wolfson Microelectronics plc