WM8952ECSSLASHRV datasheet(49/72 Pages) WOLFSON

49 / 72 page

Pre Production

WM8952

PP, Rev 3.1, June 2011

GENERAL PURPOSE INPUT/OUTPUT

In 2-wire mode, the CSB pin is not required and it can be used as a GPIO pin. In the WM8952, a

separate GPIO pin is available and this can be used for GPIO in 3-wire mode. Also in 3 wire mode,

the MODE / GPIO can be configured as a GPIO by setting the MODE_GPIO register bit

Whichever pin is used for GPIO, it is controlled from the GPIO control register R8. The GPIOSEL bits

allow the chosen pin to be configured to perform a variety of useful tasks as shown in Table 38

Note that SLOWCLKEN must be enabled when using the jack detect function.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

GPIO

control

5:4

OPCLKDIV

PLL Output clock division ratio

00=divide by 1

01=divide by 2

10=divide by 3

11=divide by 4

GPIOPOL

GPIO Polarity invert

0=Non inverted

1=Inverted

2:0

GPIOSEL

000

GPIO function select:

000=GPIO off

010=Temp ok

100=SYSCLK clock o/p

101=PLL lock

All other values: Reserved

Table 38 GPIO Control

CONTROL INTERFACE

SELECTION OF CONTROL MODE AND 2-WIRE MODE ADDRESS

The control interface can operate as either a 3-wire or 2-wire interface. The MODE / GPIO pin

determines the 2 or 3 wire mode as shown in Table 39.

The WM8952 is controlled by writing to registers through a serial control interface. A control word

consists of 24 bits. The first 7 bits (B23 to B16) are address bits that select which control register is

accessed. The remaining 16 bits (B15 to B0) are register bits, corresponding to the 16 bits in each

control register.

MODE / GPIO

INTERFACE FORMAT

Low

2 wire

Hi-Z

3 wire

High

3 wire

Table 39 Control Interface Mode Selection

USE OF MODE AS A GPIO PIN IN 3-WIRE MODE

In 3-wire mode, MODE can be used as a GPIO pin. If MODE is being used as a GPIO output, the

partner device doesn’t have to drive MODE - the pin will be pulled-up internally causing 3-wire mode

will be selected. The GPIO function is enabled by setting the MODE_GPIO register bit. The MODE

pin can then be controlled using the GPIO register bits as described in Figure 27. To use MODE as

a GPIO input, MODE must be undriven or driven high at start-up. Specifically MODE must be high or

hi-Z during an initial write to the control interface which sets the MODE_GPIO register bit. After

MODE_GPIO has been set, 3-wire mode selection is overridden internally and the MODE pin can be

used freely as a GPIO input or output.

WM8952ECS/RV Scheda tecnica(PDF) 49 Page - Wolfson Microelectronics plc

WM8952ECS/RV Scheda tecnica(HTML) 49 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

Scheda tecnica Scarica

Link URL