| Motore di ricerca datesheet componenti elettronici |
|
LSM6DSOX Scheda tecnica(PDF) 33 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
LSM6DSOX Scheda tecnica(HTML) 33 Page - STMicroelectronics |
|
33 / 199 page ![]() 6.5 OIS This paragraph describes OIS functionality. There is a dedicated gyroscope and accelerometer DSP for OIS. Other features can be configured: • Self-test on OIS side • DEN on OIS side 6.5.1 Enabling OIS functionality and connection schemes There are three different ways in order to enable and configure OIS functionality: • Auxiliary SPI full control: Enabling and configuration done from Auxiliary SPI • Enabling primary interface: Enable from primary interface, configuration from Auxiliary SPI • Primary interface full control: Enabling and configuration done from primary interface The configurations that allow selecting these three different options are done using the OIS_CTRL_FROM_UI bit in FUNC_CFG_ACCESS (01h) and the OIS_ON_EN bit in CTRL7_G (16h) as described in the following table. Table 19. OIS configurations OIS_CTRL_ FROM_UI OIS_ON_EN OIS configuration option 0 0 Auxiliary SPI full control 0 1 Enabling primary interface 1 x Primary interface full control 6.5.1.1 Auxiliary SPI full control This is the default condition of the device. The camera module is completely independent from the application processor as shown in Figure 22. The Auxiliary SPI can configure OIS functionality through SPI2_INT_OIS (6Fh), SPI2_CTRL1_OIS (70h), SPI2_CTRL2_OIS (71h), SPI2_CTRL3_OIS (72h). Reading from the Auxiliary SPI is enabled only when the OIS_EN_SPI2 bit in the SPI2_CTRL1_OIS (70h) register is set to '1'. This bit also turns on the gyroscope OIS chain. The Primary Interface can access the OIS control registers (UI_INT_OIS (6Fh), UI_CTRL1_OIS (70h), UI_CTRL2_OIS (71h), UI_CTRL3_OIS (72h)) in read mode. Note: If accelerometer Ultra-Low-Power Mode is intended to be used on the Primary chain, it is recommended to use the Primary IF enabling option instead, in order to make sure that the device is set in Power-Down (from ULP mode) before enabling the OIS chain. LSM6DSOX OIS DS12814 - Rev 3 page 33/199 |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |