| Motore di ricerca datesheet componenti elettronici |
|
WM8961 Scheda tecnica(PDF) 73 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8961 Scheda tecnica(HTML) 73 Page - Wolfson Microelectronics plc |
|
73 / 116 page ![]() WM8961 Pre-Production w PP, August 2009, Rev 3.1 73 SYSCLK SYSCLK is derived directly from MCLK. It is either MCLK or MCLK/2. The CLK_SYS_ENA enables the internal SYSCLK. The CLK_DSP_ENA allows the clock to the DSP, ADC and DAC to be disabled (for power reduction) while peripheral functions continue to be clocked by SYSCLK. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION R4 (04h) Clocking1 2 MCLKDIV 0 SYSCLK configuration. 0 : SYSCLK = MCLK/1 1 : SYSCLK = MCLK/2 R8 (08h) Clocking2 5 CLK_SYS_ENA 1 Enable system clock. Power saving feature to gate SYSTEM clock. When this bit is enabled, an MCLK must be provided to allow access to the control interface. 4 CLK_DSP_ENA 1 DSP clock enable. Power saving feature to gate clock to DSP while allowing auxiliary functions to run. Table 53 SYSCLK Configuration ADC AND DAC CLOCKING AND SAMPLE RATES The ADCDIV and DACDIV bits determine the ADC and DAC operating clock. The output of ADCDIV should be configured to output a clock of 256fs. The 256fs output of ADCDIV is further divided such that the ADC operates at 128fs. The DAC should be configured to run at a clock frequency as close as possible to 3MHz. This requires setting the DACDIV divider to output a clock of at least 64fs. ADC Example SYSCLK=12.288 MHz, and fs=24 kHz. Then ADCDIV should be set to 010 (SYSCLK/2).. This defines the output of the ADCDIV as 256fs = (12.288 MHz /2) = 6.144 MHz. This 6.144 MHz is further divided by 2 (ADC runs at 128fs) to drive the ADC. Further examples are given in Table 55. DAC Example SYSCLK=11.2896 MHz and fs=44.1 kHz. Then DACDIV should be set to =100. This defines the output of the DACDIV as 64fs = (11.2896 MHz /4) = 2.8224 MHz Further examples are given in Table 55 (when both ADC and DAC used) and Table 56 (DAC only use). In master mode the output BCLK is controlled by BCLKDIV, and the LRC is controlled by LRCLK_RATE. These are shown in Table 54 ADC, DAC and Master Mode BCLK and LRC Control. |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |