| Motore di ricerca datesheet componenti elettronici |
|
HD404369F Scheda tecnica(PDF) 79 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
HD404369F Scheda tecnica(HTML) 79 Page - Renesas Technology Corp |
|
79 / 117 page ![]() HD404369 Series 77 If more than eight transmit clocks are input in transfer state, at the eighth clock including a spurious pulse by noise, the octal counter reaches 000, the serial interrupt request flag (IFS: $003, bit 2) is set, and transmit clock wait state is entered. At the falling edge of the next normal clock signal, the transfer state is entered. After the transfer completion processing is performed and IFS is reset, writing to the serial mode register (SMR: $005) changes the state from transfer to STS wait. At this time IFS is set again, and therefore the error can be detected. Notes on Use: • Initialization after writing to registers: If port mode register A (PMRA: $004) is written to in transmit clock wait state or in transfer state, the serial interface must be initialized by writing to the serial mode register (SMR: $005) again. • Serial interrupt request flag (IFS: $003, bit 2) set: If the state is changed from transfer to another by writing to the serial mode register (SMR: $005) or executing the STS instruction during the first low pulse of the transmit clock, the serial interrupt request flag is not set. To set the serial interrupt request flag, serial mode register write or STS instruction execution must be programmed to be executed after confirming that the SCK pin is at 1, that is, after executing the input instruction to port R0. STS wait state (octal counter = 000, transmit clock disabled) Transmit clock wait state (octal counter = 000) Transfer state (octal counter ≠ 000) MCU reset 00 SMR write 04 STS instruction 01 Transmit clock 02 8 transmit clocks 03 STS instruction (IFS 1) 05 ← SMR write (IFS 1) 06 ← External clock mode STS wait state (octal counter = 000, transmit clock disabled) Transmit clock wait state (octal counter = 000) Transfer state (octal counter ≠ 000) SMR write 14 STS instruction 11 Transmit clock 12 15 STS instruction (IFS 1) ← 8 transmit clocks 13 Internal clock mode Continuous clock output state (PMRA 0, 1 = 0, 0) SMR write 18 Transmit clock 17 16 Note: Refer to the Operating States section for the corresponding encircled numbers. MCU reset 10 ← SMR write (IFS 1) Figure 59 Serial Interface State Transitions |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |