| Motore di ricerca datesheet componenti elettronici |
|
H8S/2218 Scheda tecnica(PDF) 421 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2218 Scheda tecnica(HTML) 421 Page - Renesas Technology Corp |
|
421 / 750 page ![]() Section 12 Serial Communication Interface Rev.6.00 Jun. 03, 2008 Page 373 of 698 REJ09B0074-0600 12.3.6 Serial Control Register (SCR) SCR is a register that enables or disables SCI transfer operations and interrupt requests, and is also used to selection of the transfer clock source. For details on interrupt requests, refer to section 12.9, Interrupts. Some bits in SCR have different functions in normal mode and smart card interface mode. • Normal Serial Communication Interface Mode (When SMIF in SCMR is 0) Bit Bit Name Initial Value R/W Description 7 TIE 0 R/W Transmit Interrupt Enable When this bit is set to 1, the TXI interrupt request is enabled. TXI interrupt request cancellation can be performed by reading 1 from the TDRE flag, then clearing it to 0, or clearing the TIE bit to 0. 6 RIE 0 R/W Receive Interrupt Enable When this bit is set to 1, RXI and ERI interrupt requests are enabled. RXI and ERI interrupt request cancellation can be performed by reading 1 from the RDRF flag, or the FER, PER, or ORER flag, then clearing the flag to 0, or clearing the RIE bit to 0. 5 TE 0 R/W Transmit Enable When this bit s set to 1, transmission is enabled. In this state, serial transmission is started when transmit data is written to TDR and the TDRE flag in SSR is cleared to 0. SMR setting must be performed to decide the transfer format before setting the TE bit to 1. The TDRE flag in SSR is fixed at 1 if transmission is disabled by clearing this bit to 0. 4 RE 0 R/W Receive Enable When this bit is set to 1, reception is enabled. Serial reception is started in this state when a start bit is detected in asynchronous mode or serial clock input is detected in clocked synchronous mode. SMR setting must be performed to decide the transfer format before setting the RE bit to 1. Clearing the RE bit to 0 does not affect the RDRF, FER, PER, and ORER flags, which retain their states. |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |