H8SSLASH2218 datasheet(148/750 Pages) RENESAS

148 / 750 page

Section 5 Interrupt Controller

Rev.6.00 Jun. 03, 2008 Page 100 of 698

REJ09B0074-0600

The set timing for IRQnF is shown in figure 5.3.

IRQn

input pin

IRQnF

Note: n = 7 to 0

Figure 5.3 Timing of Setting IRQnF

The detection of IRQn interrupts does not depend on whether the relevant pin has been set for

input or output. However, when a pin is used as an external interrupt input pin, do not clear the

corresponding DDR to 0; and use the pin as an I/O pin for another function. IRQnF interrupt

request flag is set when the setting condition is satisfied, regardless of IER settings. Accordingly,

refer to only necessary flags.

5.4.2

Internal Interrupts

The sources for internal interrupts from on—chip peripheral modules have the following features:

• For each on—chip peripheral module there are flags that indicate the interrupt request status,

and enable bits that select enabling or disabling of these interrupts. If both of these are set to 1

for a particular interrupt source, an interrupt request is issued to the interrupt controller.

• The interrupt priority level can be set by means of IPR.

• The DMAC can be activated by a TPU, SCI, or other interrupt request.

• When the DMAC is activated by an interrupt request, it is not affected by the interrupt control

mode or CPU interrupt mask bit.

H8S/2218 Scheda tecnica(PDF) 148 Page - Renesas Technology Corp