HD6432138SW datasheet(155/1061 Pages) RENESAS

155 / 1061 page

Section 5 Interrupt Controller

Rev. 4.00 Jun 06, 2006 page 101 of 1004

REJ09B0301-0400

Section 5 Interrupt Controller

5.1

Overview

5.1.1

Features

H8S/2138 Group and H8S/2134 Group MCUs control interrupts by means of an interrupt

controller. The interrupt controller has the following features:

• Two interrupt control modes

 Either of two interrupt control modes can be set by means of the INTM1 and INTM0 bits

in the system control register (SYSCR).

• Priorities settable with ICR

 An interrupt control register (ICR) is provided for setting interrupt priorities. Three priority

levels can be set for each module for all interrupts except NMI and address break.

• Independent vector addresses

 All interrupt sources are assigned independent vector addresses, making it unnecessary for

the source to be identified in the interrupt handling routine.

• Fifteen external interrupt pins (nine external sources)

 NMI is the highest-priority interrupt, and is accepted at all times. A rising or falling edge at

the NMI pin can be selected for the NMI interrupt.

 Falling edge, rising edge, or both edge detection, or level sensing, at pins IRQ7 to IRQ0

can be selected for interrupts IRQ7 to IRQ0.

 The IRQ6 interrupt is shared by the interrupt from the IRQ6 pin and eight external interrupt

inputs (

KIN7 to KIN0).

• DTC control

 DTC activation is controlled by means of interrupts.

HD6432138SW Scheda tecnica(PDF) 155 Page - Renesas Technology Corp