H8SSLASH2218 datasheet(385/750 Pages) RENESAS

385 / 750 page

Section 9 16-Bit Timer Pulse Unit (TPU)

Rev.6.00 Jun. 03, 2008 Page 337 of 698

REJ09B0074-0600

Contention between TCNT Write and Overflow/Underflow: If there is an up-count or down-

count in the T2 state of a TCNT write cycle, and overflow/underflow occurs, the TCNT write takes

precedence and the TCFV/TCFU flag in TSR is not set. Figure 9.53 shows the operation timing

when there is contention between TCNT write and overflow.

Write signal

Address

TCNT address

TCNT

TCNT write cycle

H'FFFF

TCNT write data

TCFV flag

Prohibited

Figure 9.53 Contention between TCNT Write and Overflow

Multiplexing of I/O Pins: In this LSI, the TCLKA input pin is multiplexed with the TIOCC0 I/O

pin, the TCLKB input pin with the TIOCD0 I/O pin, the TCLKC input pin with the TIOCB1 I/O

pin, and the TCLKD input pin with the TIOCB2 I/O pin. When an external clock is input, compare

match output should not be performed from a multiplexed pin.

Interrupts in Module Stop Mode: If module stop mode is entered when an interrupt has been

requested, it will not be possible to clear the CPU interrupt source or the DMAC activation source.

Interrupts should therefore be disabled before entering module stop mode.

Module Stop Mode Setting: TPU operation can be disabled or enabled using the module stop

control register. The initial setting is for TPU operation to be halted. Register access is enabled by

clearing module stop mode. For details, refer to section 20, Power-Down Modes.

H8S/2218 Scheda tecnica(PDF) 385 Page - Renesas Technology Corp