H8SSLASH2218 datasheet(634/750 Pages) RENESAS

634 / 750 page

Section 17 Flash Memory (F-ZTAT Version)

Rev.6.00 Jun. 03, 2008 Page 586 of 698

REJ09B0074-0600

17.12

Power-Down States for Flash Memory

In user mode, the flash memory will operate in either of the following states:

• Normal operating mode

The flash memory can be read and written to.

• Standby mode

All flash memory circuits are halted.

• Power-down state

The flash memory can be read when part of the power supply circuit is halted and the LSI

operates by subclocks.

Table 17.8 shows the correspondence between the operating modes of this LSI and the flash

memory. When the flash memory returns to normal operation from a power-down state, a power

supply circuit stabilization period is needed. When the flash memory returns to its normal

operating state from watch mode or standby mode, bits STS2 to STS0 in SBYCR must be set to

provide a wait time of at least 100

μs; when returns from flash memory module stop mode, the

software wait state should be set.

Table 17.8

Flash Memory Operating States

LSI Operating State

Flash Memory Operating State

Active mode

Normal operating mode

Sleep mode

Watch mode

Standby mode

Flash memory module stop

mode

Standby mode

(Before entering to the normal operation mode, wait time of at least

100 µs is required.)

Subactive mode

Subsleep mode

Power-down mode (read only)

H8S/2218 Scheda tecnica(PDF) 634 Page - Renesas Technology Corp