H8SSLASH2218 datasheet(218/750 Pages) RENESAS

218 / 750 page

Section 7 DMA Controller (DMAC)

Rev.6.00 Jun. 03, 2008 Page 170 of 698

REJ09B0074-0600

Bit Bit Name Initial Value

R/W

Description

DTA1B

DTA1A

DTA0B

DTA0A

R/W

Data Transfer Acknowledge

These bits enable or disable clearing, when DMA transfer is

performed, of the internal interrupt source selected by the

data transfer factor setting.

When DTE = 1 and DTA = 1, the internal interrupt source

selected by the data transfer factor setting is cleared

automatically by DMA transfer. When DTE = 1 and DTA = 1,

the internal interrupt source selected by the data transfer

factor setting does not issue an interrupt request to the CPU.

When DTE = 1 and DTA = 0, the internal interrupt source

selected by the data transfer factor setting is not cleared

when a transfer is performed, and can issue an interrupt

request to the CPU in parallel. In this case, the interrupt

source should be cleared by the CPU.

When DTE = 0, the internal interrupt source selected by the

data transfer factor setting issues an interrupt request to the

CPU regardless of the DTA bit setting.

0: Clearing of selected internal interrupt source at time of

DMA transfer is disabled

1: Clearing of selected internal interrupt source at time of

DMA transfer is enabled

H8S/2218 Scheda tecnica(PDF) 218 Page - Renesas Technology Corp