ATtiny261-ESSZ datasheet(160/227 Pages) ATMEL

160 / 227 page

160

7753C–AVR–07/09

ATtiny261/ATtiny461/ATtiny861

19.10.2

ADCSRA – ADC Control and Status Register A

• Bit 7 – ADEN: ADC Enable

Writing this bit to one enables the ADC. By writing it to zero, the ADC is turned off. Turning the

ADC off while a conversion is in progress, will terminate this conversion.

• Bit 6 – ADSC: ADC Start Conversion

In Single Conversion mode, write this bit to one to start each conversion. In Free Running mode,

write this bit to one to start the first conversion. The first conversion after ADSC has been written

after the ADC has been enabled, or if ADSC is written at the same time as the ADC is enabled,

will take 25 ADC clock cycles instead of the normal 13. This first conversion performs initializa-

tion of the ADC.

ADSC will read as one as long as a conversion is in progress. When the conversion is complete,

it returns to zero. Writing zero to this bit has no effect.

• Bit 5 – ADATE: ADC Auto Trigger Enable

When this bit is written to one, Auto Triggering of the ADC is enabled. The ADC will start a con-

version on a positive edge of the selected trigger signal. The trigger source is selected by setting

the ADC Trigger Select bits, ADTS in ADCSRB.

• Bit 4 – ADIF: ADC Interrupt Flag

This bit is set when an ADC conversion completes and the data registers are updated. The ADC

Conversion Complete Interrupt is executed if the ADIE bit and the I-bit in SREG are set. ADIF is

cleared by hardware when executing the corresponding interrupt handling vector. Alternatively,

ADIF is cleared by writing a logical one to the flag. Beware that if doing a Read-Modify-Write on

ADCSRA, a pending interrupt can be disabled. This also applies if the SBI and CBI instructions

are used.

• Bit 3 – ADIE: ADC Interrupt Enable

When this bit is written to one and the I-bit in SREG is set, the ADC Conversion Complete Inter-

rupt is activated.

• Bits 2:0 – ADPS2:0: ADC Prescaler Select Bits

These bits determine the division factor between the system clock frequency and the input clock

to the ADC.

Bit

6543

210

0x06 (0x26)

ADEN

ADSC

ADATE

ADIF

ADIE

ADPS2

ADPS1

ADPS0

ADCSRA

Read/Write

R/W

Initial Value

0000

000

ATtiny261-ESSZ Scheda tecnica(PDF) 160 Page - ATMEL Corporation

ATtiny261-ESSZ Scheda tecnica(HTML) 160 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL