CDPCLK4 datasheet(162/274 Pages) ALTERA

162 / 274 page

9–4

Chapter 9: Configuration, Design Security, and Remote System Upgrades in the Cyclone III Device Family

Configuration Features

Cyclone III Device Handbook

August 2012

Altera Corporation

Volume 1

When you enable compression, the Quartus II software generates configuration files

with compressed configuration data. This compressed file reduces the storage

requirements in the configuration device or flash memory and decreases the time

needed to send the bitstream to the Cyclone III device family. The time needed by a

Cyclone III device family to decompress a configuration file is less than the time

needed to send the configuration data to the device. There are two methods for

enabling compression for Cyclone III device family bitstreams in the Quartus II

software:

■

Before design compilation (using the Compiler Settings menu).

■

After design compilation (use the Convert Programming Files dialog box).

To enable compression in the compiler settings of the project in the Quartus II

software, perform the following steps:

1. On the Assignments menu, click Device. The Settings dialog box appears.

2. Click Device and Pin Options. The Device and Pin Options dialog box appears.

3. Click the Configuration tab.

4. Turn on Generate compressed bitstreams (Figure 9–1).

5. Click OK.

6. In the Settings dialog box, click OK.

To enable compression when creating programming files from the Convert

Programming Files

window, follow these steps:

1. On the File menu, click Convert Programming Files.

Figure 9–1. Enabling Compression for Cyclone III Device Family Bitstreams in Compiler Settings

CDPCLK4 Scheda tecnica(PDF) 162 Page - Altera Corporation