H8SSLASH2214 datasheet(339/936 Pages) RENESAS

339 / 936 page

Section 8 Data Transfer Controller (DTC)

Rev.4.00 Sep. 18, 2008 Page 279 of 872

REJ09B0189-0400

(2) Software Activation

An example is shown in which the DTC is used to transfer a block of 128 bytes of data by means

of software activation. The transfer source address is H'1000 and the destination address is

H'2000. The vector number is H'60, so the vector address is H'04C0.

[1] Set MRA to incrementing source address (SM1 = 1, SM0 = 0), incrementing destination

address (DM1 = 1, DM0 = 0), block transfer mode (MD1 = 1, MD0 = 0), and byte size (Sz =

0). The DTS bit can have any value. Set MRB for one block transfer by one interrupt (CHNE =

0). Set the transfer source address (H'1000) in SAR, the destination address (H'2000) in DAR,

and 128 (H'8080) in CRA. Set 1 (H'0001) in CRB.

[2] Set the start address of the register information at the DTC vector address (H'04C0).

[3] Check that the SWDTE bit in DTVECR is 0. Check that there is currently no transfer activated

by software.

[4] Write 1 to the SWDTE bit and the vector number (H'60) to DTVECR. The write data is H'E0.

[5] Read DTVECR again and check that it is set to the vector number (H'60). If it is not, this

indicates that the write failed. This is presumably because an interrupt occurred between steps

3 and 4 and led to a different software activation. To activate this transfer, go back to step 3.

[6] If the write was successful, the DTC is activated and a block of 128 bytes of data is transferred.

[7] After the transfer, an SWDTEND interrupt occurs. The interrupt handling routine should clear

the SWDTE bit to 0 and perform other wrap-up processing.

H8S/2214 Scheda tecnica(PDF) 339 Page - Renesas Technology Corp