H8SSLASH2224 datasheet(705/1071 Pages) RENESAS

705 / 1071 page

Section 15 Serial Communication Interface (SCI)

Rev. 5.00 Aug 08, 2006 page 619 of 982

REJ09B0054-0500

When turning on the power or switching between Smart Card interface mode and software standby

mode, the following procedures should be followed in order to maintain the clock duty.

Powering On: To secure clock duty from power-on, the following switching procedure should be

followed.

1. The initial state is port input and high impedance. Use a pull-up resistor or pull-down resistor

to fix the potential.

2. Fix the SCK pin to the specified output level with the CKE1 bit in SCR.

3. Set SMR and SCMR, and switch to smart card mode operation.

4. Set the CKE0 bit in SCR to 1 to start clock output.

When changing from smart card interface mode to software standby mode:

1. Set the data register (DR) and data direction register (DDR) corresponding to the SCK pin to

the value for the fixed output state in software standby mode.

2. Write 0 to the TE bit and RE bit in the serial control register (SCR) to halt transmit/receive

operation. At the same time, set the CKE1 bit to the value for the fixed output state in software

standby mode.

3. Write 0 to the CKE0 bit in SCR to halt the clock.

4. Wait for one serial clock period.

During this interval, clock output is fixed at the specified level, with the duty preserved.

5. Make the transition to the software standby state.

When returning to smart card interface mode from software standby mode:

1. Exit the software standby state.

2. Write 1 to the CKE0 bit in SCR and output the clock. Signal generation is started with the

normal duty.

Software

standby

Normal operation

Figure 15.35 Clock Halt and Restart Procedure

H8S/2224 Scheda tecnica(PDF) 705 Page - Renesas Technology Corp