H8SSLASH2214 datasheet(310/936 Pages) RENESAS

310 / 936 page

Section 7 DMA Controller

Rev.4.00 Sep. 18, 2008 Page 250 of 872

REJ09B0189-0400

(6) Internal Interrupt after End of Transfer

When the DTE bit is cleared to 0 by the end of transfer or an abort, the selected internal interrupt

request will be sent to the CPU or DTC even if DTA is set to 1.

Also, if internal DMAC activation has already been initiated when operation is aborted, the

transfer is executed but flag clearing is not performed for the selected internal interrupt even if

DTA is set to 1.

An internal interrupt request following the end of transfer or an abort should be handled by the

CPU as necessary.

(7) Channel Re-Setting

To reactivate a number of channels when multiple channels are enabled, use exclusive handling of

transfer end interrupts, and perform DMABCR control bit operations exclusively.

Note, in particular, that in cases where multiple interrupts are generated between reading and

writing of DMABCR, and a DMABCR operation is performed during new interrupt handling, the

DMABCR write data in the original interrupt handling routine will be incorrect, and the write may

invalidate the results of the operations by the multiple interrupts. Ensure that overlapping

DMABCR operations are not performed by multiple interrupts, and that there is no separation

between read and write operations by the use of a bit-manipulation instruction.

Also, when the DTE and DTME bits are cleared by the DMAC or are written with 0, they must

first be read while cleared to 0 before the CPU can write a 1 to them.

H8S/2214 Scheda tecnica(PDF) 310 Page - Renesas Technology Corp