H8SSLASH2224 datasheet(519/1071 Pages) RENESAS

Il numero della parte	H8S/2224

Spiegazioni elettronici	16-Bit Single-Chip Microcomputer H8S Family/H8S/2200 Series

PDF	1071 Pages

Scroll/Zoom	100%

Produttore elettronici	RENESAS [Renesas Technology Corp]

Homepage	http://www.renesas.com

Logo

519 / 1071 page

Section 11 16-Bit Timer Pulse Unit (TPU)

Rev. 5.00 Aug 08, 2006 page 433 of 982

REJ09B0054-0500

Interrupt

request

signal

Status flag

Address

Source address

DTC/DMAC*

read cycle

Destination

address

DTC/DMAC*

write cycle

Note: * Supported only by the H8S/2239 Group.

Figure 11.44 Timing for Status Flag Clearing by DTC/DMAC* Activation

Note: * Supported only by the H8S/2239 Group.

11.10 Usage Notes

11.10.1 Module Stop Mode Setting

TPU operation can be disabled or enabled using the module stop control register. The initial

setting is for TPU operation to be halted. Register access is enabled by clearing module stop mode.

For details, refer to section 24, Power-Down Modes.

11.10.2 Input Clock Restrictions

The input clock pulse width must be at least 1.5 states in the case of single-edge detection, and at

least 2.5 states in the case of both-edge detection. The TPU will not operate properly with a

narrower pulse width.

In phase counting mode, the phase difference and overlap between the two input clocks must be at

least 1.5 states, and the pulse width must be at least 2.5 states. Figure 11.45 shows the input clock

conditions in phase counting mode.

H8S/2224 Scheda tecnica(PDF) 519 Page - Renesas Technology Corp