H8SSLASH2224 datasheet(630/1071 Pages) RENESAS

630 / 1071 page

Section 14 IEBus™ Controller (IEB) [H8S/2258 Group]

Rev. 5.00 Aug 08, 2006 page 544 of 982

REJ09B0054-0500

(3) DLE Flag

When retransfer is performed up to the maximum number of transfer bytes defined by the protocol

because of reception of a NAK caused by a parity or an overrun error during data field reception,

the number of transferred bytes may be greater than that of bytes specified by the message length.

At this time the DLE flag is set. Moreover, when the value of the message length bits is greater

than the maximum number of transfer bytes, the DLE flag is also set. The DLE flag is not set if the

maximum number of transfer bytes defined by the protocol is specified and the transfer is

performed correctly.

If the DLE flag is set to 1, the RxE flag is set to 1 and the wait state is entered.

(4) PE Flag

If a parity error occurs after reception starts (the RxS flag is set to 1), a NAK is sent to perform re-

reception.

If a parity error is not cleared when the maximum number of transfer bytes specified by the

protocol is received, the PE flag is set to 1, the RxE flag is set to 1 and the wait state is entered. If

a parity error is cleared during the rereception and if the following data is received correctly, the

PE flag is not set.

Notes: 1. If the reception is performed up to the maximum number of transfer bytes defined by

the protocol because of a parity or an overrun error during data field reception, the

number of receive bytes is less than that of bytes specified by the message length bits,

no parity error or overrun error may occur at the last byte reception. In this case, the

DLE flag is set. However, the OVE and PE flags are not set.

2. The flags in IEREF are set after reception starts. Accordingly, the RxE flag is valid and

set after the RxS flag has been set. If an error occurs before reception starts, the frame

is discarded and no interrupt occurs.

14.6.6

Notes on Slave Transmission

When the slave unit transmits the slave status and upper and lower locked addresses, a parity or an

overrun error occurs in the master reception side and the data cannot be received. Accordingly,

even if a NAK is returned, the slave unit is not capable of retransfer.

In this case, the master unit must discard the frame in which an error occurred and request the

above operation in the master reception to receive the correct frame.

H8S/2224 Scheda tecnica(PDF) 630 Page - Renesas Technology Corp