H8SSLASH2214 datasheet(526/936 Pages) RENESAS

526 / 936 page

Section 12 Serial Communication Interface (SCI)

Rev.4.00 Sep. 18, 2008 Page 466 of 872

REJ09B0189-0400

Bit 3

MPIE

Description

Multiprocessor interrupts disabled (normal reception performed)

(Initial value)

[Clearing conditions]

• When the MPIE bit is cleared to 0

• When MPB= 1 data is received

Multiprocessor interrupts enabled*

Receive interrupt (RXI) requests, receive error interrupt (ERI) requests, and setting

of the RDRF, FER, and ORER flags in SSR are disabled until data with the

multiprocessor bit set to 1 is received.

Note: * When receive data including MPB = 0 is received, receive data transfer from RSR to RDR,

receive error detection, and setting of the RDRF, FER, and ORER flags in SSR , is not

performed. When receive data including MPB = 1 is received, the MPB bit in SSR is set to

1, the MPIE bit is cleared to 0 automatically, and generation of RXI and ERI interrupts

(when the TIE and RIE bits in SCR are set to 1) and FER and ORER flag setting is

enabled.

Bit 2—Transmit End Interrupt Enable (TEIE): Enables or disables transmit end interrupt

(TEI) request generation when there is no valid transmit data in TDR in MSB data transmission.

Bit 2

TEIE

Description

Transmit end interrupt (TEI) request disabled*

(Initial value)

Transmit end interrupt (TEI) request enabled*

Note: * TEI cancellation can be performed by reading 1 from the TDRE flag in SSR, then clearing

it to 0 and clearing the TEND flag to 0, or clearing the TEIE bit to 0.

Bits 1 and 0—Clock Enable 1 and 0 (CKE1, CKE0): These bits are used to select the SCI clock

source and enable or disable clock output from the SCK pin. The combination of the CKE1 and

CKE0 bits determines whether the SCK pin functions as an I/O port, the serial clock output pin, or

the serial clock input pin.

The setting of the CKE0 bit, however, is only valid for internal clock operation (CKE1 = 0) in

asynchronous mode. The CKE0 bit setting is invalid in clocked synchronous mode, and in the case

of external clock operation (CKE1 = 1). Note that the SCI’s operating mode must be decided using

SMR after setting the CKE1 and CKE0 bits.

For details of clock source selection, see table 12.9.

H8S/2214 Scheda tecnica(PDF) 526 Page - Renesas Technology Corp