ATtiny261A datasheet(128/292 Pages) ATMEL

128 / 292 page

128

8197A–AVR–10/09

ATtiny261A/461A/861A

Figure 13-4. Two-wire Mode Operation, Simplified Diagram

The data direction is not given by the physical layer. A protocol, like the one used by the TWI-

bus, must be implemented to control the data flow.

Figure 13-5. Two-wire Mode, Typical Timing Diagram

Referring to the timing diagram (Figure 13-5), a bus transfer involves the following steps:

1. The start condition is generated by the master by forcing the SDA low line while keep-

ing the SCL line high (A). SDA can be forced low either by writing a zero to bit 7 of the

USI Data Register, or by setting the corresponding bit in the PORTA register to zero.

Note that the Data Direction Register bit must be set to one for the output to be

enabled. The start detector logic of the slave device (see Figure 13-6 on page 129)

detects the start condition and sets the USISIF Flag. The flag can generate an interrupt

if necessary.

2. In addition, the start detector will hold the SCL line low after the master has forced a

negative edge on this line (B). This allows the slave to wake up from sleep or complete

other tasks before setting up the USI Data Register to receive the address. This is done

by clearing the start condition flag and resetting the counter.

MASTER

SLAVE

Bit7

Bit6

Bit5

Bit4

Bit3

Bit2

Bit1

Bit0

SDA

SCL

Bit7

Bit6

Bit5

Bit4

Bit3

Bit2

Bit1

Bit0

Two-wire Clock

Control Unit

HOLD

SCL

PORTxn

SDA

SCL

VCC

ADDRESS

1 - 7

R/W

ACK

1 - 8

DATA

ACK

1 - 8

DATA

SDA

SCL

A B

ATtiny261A Scheda tecnica(PDF) 128 Page - ATMEL Corporation

ATtiny261A Scheda tecnica(HTML) 128 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL