MX25L3233F datasheet(57/84 Pages) MCNIX

Il numero della parte	MX25L3233F

Spiegazioni elettronici	3V, 32M-BIT [x 1/x 2/x 4] CMOS MXSMIO짰 (SERIAL MULTI I/O) FLASH MEMORY

PDF	84 Pages

Scroll/Zoom	100%

Produttore elettronici	MCNIX [Macronix International]

Homepage	http://www.macronix.com

Logo

57 / 84 page

MX25L3233F

P/N: PM2113

Rev. 1.6, March 10, 2017

10-30. No Operation (NOP)

The "No Operation" command is only able to terminate the Reset Enable (RSTEN) command and will not affect

any other command.

10-31. Software Reset (Reset-Enable (RSTEN) and Reset (RST))

The Software Reset operation combines two instructions: Reset-Enable (RSTEN) command and Reset (RST)

command. It returns the device to a standby mode. All the volatile bits and settings will be cleared then, which

makes the device return to the default status as power on.

To execute Reset command (RST), the Reset-Enable (RSTEN) command must be executed first to perform the

Reset operation. If there is any other command to interrupt after the Reset-Enable command, the Reset-Enable

will be invalid.

If the Reset command is executed during program or erase operation, the operation will be disabled, the data un-

der processing could be damaged or lost.

The reset time is different depending on the last operation. Longer latency time is required to recover from a pro-

gram operation than from other operations.

Figure 36. Software Reset Recovery

CS#

Mode

Stand-by Mode

tRCR

tRCP

tRCE

MX25L3233F Scheda tecnica(PDF) 57 Page - Macronix International