AT83SND1CXXX-ROTIL datasheet(88/212 Pages) ATMEL

88 / 212 page

4109J–8051–10/06

AT8xC51SND1C

point FIFO before clearing the RXOUTB1 bit. Until the RXOUTB1 bit has been cleared by the

firmware, the USB controller will answer a NAK handshake for each OUT requests on the bank 1

endpoint FIFO.

The RXOUTB0 and RXOUTB1 bits are, alternatively, set by the USB controller at each new valid

packet receipt.

The firmware has to clear one of these 2 bits after having read all the data FIFO to allow a new

valid packet to be stored in the corresponding bank.

A NAK handshake is sent by the USB controller only if the banks 0 and 1 has not been released

by the firmware.

If the Host sends more Bytes than supported by the endpoint FIFO, the overflow data won’t be

stored, but the USB controller will consider that the packet is valid if the CRC is correct.

14.4.3

Bulk/Interrupt IN Transactions in Standard Mode

Figure 14-11. Bulk/Interrupt IN Transactions in Standard Mode

An endpoint should be first enabled and configured before being able to send Bulk or Interrupt

packets.

The firmware should fill the FIFO with the data to be sent and set the TXRDY bit in the UEP-

STAX register to allow the USB controller to send the data stored in FIFO at the next IN request

concerning this endpoint. To send a Zero Length Packet, the firmware should set the TXRDY bit

without writing any data into the endpoint FIFO.

Until the TXRDY bit has been set by the firmware, the USB controller will answer a NAK hand-

shake for each IN requests.

To cancel the sending of this packet, the firmware has to reset the TXRDY bit. The packet stored

in the endpoint FIFO is then cleared and a new packet can be written and sent.

When the IN packet has been sent and acknowledged by the Host, the TXCMPL bit in the UEP-

STAX register is set by the USB controller. This triggers a USB interrupt if enabled. The firmware

should clear the TXCMPL bit before filling the endpoint FIFO with new data.

The firmware should never write more Bytes than supported by the endpoint FIFO.

DATA0 (n Bytes)

ACK

HOST

UFI

C51

Endpoint FIFO Write Byte 1

NAK

TXCMPL

Endpoint FIFO Write Byte 2

Endpoint FIFO Write Byte n

Set TXRDY

Clear TXCMPL

Endpoint FIFO Write Byte 1

AT83SND1CXXX-ROTIL Scheda tecnica(PDF) 88 Page - ATMEL Corporation

AT83SND1CXXX-ROTIL Scheda tecnica(HTML) 88 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL