AT83SND1CXXX-ROTIL datasheet(47/212 Pages) ATMEL

47 / 212 page

4109J–8051–10/06

AT8xC51SND1C

Power Management

2 power reduction modes are implemented in the AT8xC51SND1C: the Idle mode and the

Power-down mode. These modes are detailed in the following sections. In addition to these

power reduction modes, the clocks of the core and peripherals can be dynamically divided by 2

using the X2 mode detailed in section “X2 Feature”, page 12.

9.1

Reset

In order to start-up (cold reset) or to restart (warm reset) properly the microcontroller, an high

level has to be applied on the RST pin. A bad level leads to a wrong initialization of the internal

registers like SFRs, Program Counter… and to unpredictable behavior of the microcontroller. A

proper device reset initializes the AT8xC51SND1C and vectors the CPU to address 0000h. RST

input has a pull-down resistor allowing power-on reset by simply connecting an external capaci-

tor to VDD as shown in Figure 9-1. A warm reset can be applied either directly on the RST pin or

indirectly by an internal reset source such as the watchdog timer. Resistor value and input char-

acteristics are discussed in the Section “DC Characteristics” of the AT8xC51SND1C datasheet.

The status of the Port pins during reset is detailed in Table 47.

Figure 9-1.

Reset Circuitry and Power-On Reset

Table 47. Pin Conditions in Special Operating Modes

Note:

1. Refer to section “Audio Output Interface”, page 73.

9.1.1

Cold Reset

2 conditions are required before enabling a CPU start-up:

•V

DD must reach the specified VDD range

•

The level on X1 input pin must be outside the specification (V

IH, VIL)

If one of these 2 conditions are not met, the microcontroller does not start correctly and can exe-

cute an instruction fetch from anywhere in the program space. An active level applied on the

RST pin must be maintained till both of the above conditions are met. A reset is active when the

level V

IH1 is reached and when the pulse width covers the period of time where VDD and the

oscillator are not stabilized. 2 parameters have to be taken into account to determine the reset

pulse width:

•V

DD rise time,

•

Oscillator startup time.

Mode

Port 0

Port 1

Port 2

Port 3

Port 4

Port 5

MMC

Audio

Reset

Floating

High

Floating

Idle

Data

Power-down

Data

RST

VSS

To CPU Core

and Peripherals

RST

VDD

Power-on Reset

RST input circuitry

VDD

From Internal

Reset Source

AT83SND1CXXX-ROTIL Scheda tecnica(PDF) 47 Page - ATMEL Corporation

AT83SND1CXXX-ROTIL Scheda tecnica(HTML) 47 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL