HC05V7GRSSLASHD datasheet(87/170 Pages) NXP

87 / 170 page

SECTION 11: 16-BIT TIMER

Page 73

MC68HC05V7 Specification Rev. 1.0

11.5.1

ICF - Input Capture Flag

1 - Flag set when selected polarity edge is sensed by input capture edge

detector

0 - Flag cleared when TSR and input capture low register ($15) are

accessed

Reset clears this bit.

11.5.2

OCF - Output Compare Flag

1 - Flag set when output compare register contents match the free-running

counter contents

0 - Flag cleared when TSR and output compare low register ($17) are

accessed

Reset clears this bit.

11.5.3

TOF - Timer Overflow Flag

1 - Flag set when free-running counter transition from $FFFF to $0000

occurs

0 - Flag cleared when TSR and counter low register ($19) are accessed

Reset clears this bit.

11.5.4

Bits 0-4 - Not used

Always read zero.

Accessing the timer status register satisfies the first condition required to clear status bits.

The remaining step is to access the register corresponding to the status bit.

A problem can occur when using the timer overflow function and reading the free-running

counter at random times to measure an elapsed time. Without incorporating the proper

precautions into software, the timer overflow flag could unintentionally be cleared if:

1. The timer status register is read or written when TOF is set, and

2. The MSB of the free-running counter is read but not for the purpose of

servicing the flag.

The counter alternate register at address $1A and $1B contains the same value as the free-

running counter (at address $18 and $19); therefore, this alternate register can be read at

any time without affecting the timer overflow flag in the timer status register.

11.6

TIMER DURING WAIT MODE

The CPU clock halts during the WAIT mode, but the timer remains active if turned on prior

to entering wait mode. If interrupts are enabled, a timer interrupt will cause the processor

to exit the WAIT mode.

11.7

TIMER DURING STOP MODE

In the STOP mode, the timer stops counting and holds the last count value if STOP is exited

by an interrupt. If RESET is used, the counter is forced to $FFFC. During STOP, if the

TIMER is on and at least one valid input capture edge occurs at the TCAP pin, the input

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC05V7GRS/D Scheda tecnica(PDF) 87 Page - NXP Semiconductors

HC05V7GRS/D Scheda tecnica(HTML) 87 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL